Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Ciscoworks LMS 3.2.2

Is it possible using any module in CW to get the MAC address and IP address of all switchports on a 6500?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Ciscoworks LMS 3.2.2

Nope, UT will find them. The end host component, UTLite, is only needed to provide Windows usernames to UT. Even without it, UT will find the MAC and IP.

6 REPLIES
Cisco Employee

Re: Ciscoworks LMS 3.2.2

If you mean obtain the MAC and IP addresses of end hosts connected to the switch, then, yes. The User Tracking module in Campus Manager does this.

Community Member

Re: Ciscoworks LMS 3.2.2

Yes, that is exactly what i'm looking for, but the devices hanging off my switch are all servers. Will that pose any issues. My understanding was you need to have the user tracking piece on each machine to accomplish this.

Thanks,

Nick

Re: Ciscoworks LMS 3.2.2

Hi Nick, you need UTLite on the client for this.

I am not aware of other ways.

Cisco Employee

Re: Ciscoworks LMS 3.2.2

Nope, UT will find them. The end host component, UTLite, is only needed to provide Windows usernames to UT. Even without it, UT will find the MAC and IP.

Community Member

Re: Ciscoworks LMS 3.2.2

Great...let me give it a run...thanks for everyone's help.

Community Member

Ciscoworks LMS 3.2.2

Most importantly CW LMS is only up to 3.2.1 not 3.2.2.

372
Views
0
Helpful
6
Replies
CreatePlease to create content