Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ciscoworks LMS 3.2 unable to recongize 3945e series routers

Ciscoworks LMS 3.2 - CS v3.3.0, RME 4.3.1

3945e Series Routers are showing up as "unknown" device type.  How can I add support for this device type?  thanks.

  • Network Management
3 REPLIES

Re: ciscoworks LMS 3.2 unable to recongize 3945e series routers

1. Run the device update from Common Services --> Software Center ---> Device Update --> Select all the applications, download update, and install it.

2. Verify that device credentials are correct for the SNMP community strings using the device credential verification from RME > Devices > Device Management > Device Credential Verification Job.

3. Post results along with the snmpwalk from Device Center using the OID 1.3.6.1.4.1.9.1.1145.

Note you must be on IOS 15.1(T) for this be supported by RME 4.3.1.

http://www.cisco.com/en/US/partner/docs/net_mgmt/ciscoworks_lan_management_solution/3.2/device_support/table/lms32sdt.html

-nael

New Member

Re: ciscoworks LMS 3.2 unable to recongize 3945e series routers

I think this is my problem.  How can I fix it?  Thanks.

The following is a SNMP walk of device 192.168.250.20 starting from .1.3.6.1.4.1.9.1.1145

SNMP Walk Output
--------------------------------------------------------------------------------
.1.3.6.1.4.1.9.1.1145

.1.3.6.1.4.1.9.1.1145 = No Such Object available on this agent at this OID

Re: ciscoworks LMS 3.2 unable to recongize 3945e series routers

Post the show ver from the device.

One thing you can do is try manually setting the device type from common services by removing and re-adding it and get the sysobect id from snmpwalk using the following:

snmpwalk -v2c -c (read only community string)  (deviceip) sysobject

(i.e "snmpwalk -v2c -c public  1.1.1.1 sysobject")

416
Views
0
Helpful
3
Replies
This widget could not be displayed.