Re: CiscoWorks LMS 3.2 Won't Start on Windows Server 2008 Enterp
There could be several reasons this happens. Common one in Windows 2008 is the swap is not set properly as it defaults to "Automatically manage paging file size for all drives". Try setting the swap to 8GB manually or whichever is the recommendation for your current device count as per:
R2 is not supported, but according to the information on this link it is expected to be supported in LMS 4.0 in December. If you have had installation problems, you should strictly follow the suggestions here including proper cleanup steps which can be verified by TAC. This should lead to a successful installation on any of the supported platforms.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...