Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Ciscoworks LMS 4.0 – Email Notifications Issue

We currently use Ciscoworks LMS 4.0 with over 1000 devices in the database. I'm a LMS novice. And have been assigned the task of minimising the amount of email notification’s we receive, as if one device goes Operationally Down all devices off that switch also send alerts to the email notification group, which in turn overwhelms the mailbox.

The ports are configured not to log or send snmp traps.

no logging event link-status

no snmp trap link-status

So any advice on how we can limit these alerts being generated would be much appreciated.

Thanks in advance.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Ciscoworks LMS 4.0 – Email Notifications Issue

Hi Nessie,

Go to Monitor > Fault Settings > Setup > Fault Device Details

select the device and click on view  then Click on the hyperlink or the device name\ip address

that will bring a new window from there click on Interface and chanaged the Managed state from ture to FLASE for those interfaces for which you do not want ALERTS.

Thanks-

Afroz

[Do rate the useful post]

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
2 REPLIES
Cisco Employee

Ciscoworks LMS 4.0 – Email Notifications Issue

Hi Nessie,

Go to Monitor > Fault Settings > Setup > Fault Device Details

select the device and click on view  then Click on the hyperlink or the device name\ip address

that will bring a new window from there click on Interface and chanaged the Managed state from ture to FLASE for those interfaces for which you do not want ALERTS.

Thanks-

Afroz

[Do rate the useful post]

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
New Member

Ciscoworks LMS 4.0 – Email Notifications Issue

Thanks Afroz that works perfect

295
Views
0
Helpful
2
Replies
CreatePlease to create content