CiscoWorks LMS - CiscoView error - Can't see Cat2960 chassis
I am a litle bit new on this subject. A few days ago I started using CiscoWorks LMS. When using CiscoView function I can see almost every devices chassis, except C2960 switch. I got an error message, as folllows:
Cannot find applicable device package.
This error could be due to one of the following:
- The device package for this device type is not installed.
- Device support for this device type is not available.
- You are trying to open a component inside a device.
To correct the problem, either install a device package for the device type, or open the parent device to manage the component.
Can anyone tell me what's the most appropriate approach to solve this problem?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.