cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
404
Views
5
Helpful
1
Replies

CiscoWorks LMS2.6 install

Steve Chapman
Level 1
Level 1

I am installing a new upgraded ciscoworks LMS 2.6 CD. This is a clean install not upgrade. While installing RME I entered the serial and PAK from the card that came with the box. I got a message at the end.

"YOU HAVE ENTER AN UPGRADE PIN.

PLEASE OBTAIN A VALID UPGRADE LICENSE KEY FROM ccO

THEN LOAD THIS LICENSE KEY INTO CISCOWORKS BY CLICKING ON SERVER--ADMIN---LICENSING

AFTER ENTERING THE LICENSE KEY, PLEASE RUN THE PROGRAM <MSROOT>/BIN/VALIDATEUPGRADE TO VALIDATE THE UPGRADE."

How do I get a correct License key?

1 Reply 1

Joe Clarke
Cisco Employee
Cisco Employee

You can contact licensing@cisco.com, or open a service request with the license team.

However, if you purchased on upgrade part number, then you are expected to have LMS 2.2 or RWAN 1.3. If not, you will not be able to fully license LMS 2.6. Once you have your upgrade license, you will need to insert the RME 3.5 CD and DFM 1.2 CD to validate that you have a qualifying previous version.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco