i have lms 2.6 and i am trying to do a netconfig job via rme >tools>netshow>netshow jobs>create -- to execute the commands "show pas vsa statistics and show crypto eli
Initially i got the error ERROR:RME_CDL1045:Pre-Device deploy operation failed, Device not found in RME..Then i stopped the ciscoworks services and rmedb password has been resetted. Later on I deleted the device in common services and added it again. Then i did an update inventory thru device center and again tried to do a netconfig job. There i found that the job has been failed with the error message as " status->failure, Protocol used->Telnet, Message->Deploy command partially failed. When i click on the "Failure" link, i could see that output for both the commands were showing properly in the window..
Can you please help me on this as i am failed to understand the problem..
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...