CiscoWorks: Netconfig job to change 4000 devices credentials and theri RME cred
We have to change the 4000 devices Local credentials credentials to new credentials, and at same time also want to update the RME with new credentials for these devices. Our some devices are TACACS with local credentials and some are ONLY using local credentials.
Just for a test I have created the a user-defined task in Netconfig with CLI command details as below; it does work, but device credentials are not updating in Ciscoworks. And because of this devices cannot talk with Ciscoworks again.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...