Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CiscoWorks Netconfig output location

Anyone know where the results or output of a Netconfig job go after the job runs?

I am trying to run a few show commands on some of our switches.  The job runs successfully but I don't know to find the results.

7 REPLIES
New Member

Re: CiscoWorks Netconfig output location

you can find it in the ouput archive

http://servername:1741/rme/NetshowOutputArchives.do

If you view the report, click on the Printer icon, than the result (output of your show commands) is displayed in a single report

New Member

Re: CiscoWorks Netconfig output location

Thanks for the reply vergeerf.  Unfortunatetly, that URL only shows me the NetShow output, not the NetConfig output.  I found the location finally by searching through our CiscoWorks server:

/var/adm/CSCOpx/files/rme/jobs/NetConfigJob/

New Member

Re: CiscoWorks Netconfig output location

to "run a few show commands on some of our switches" you better use NetShow not NetConfig..... but glad you found it :-)

Regards,

Frank

New Member

Re: CiscoWorks Netconfig output location

Good point!  I hadn't considered running the Netshow option.  I'll check it out.

BTW, I was using the Adhoc option in Netconfig to run my "show" commands.

Cisco Employee

Re: CiscoWorks Netconfig output location

Vergeerf is right.  Don't use Netconfig to do this.  It's not geared toward the output piece.  Use Netconfig to do things like clear counters, trigger EEM policies, or reset VTY lines.  Use Netshow to run commands where you care about the actual output.

New Member

Re: CiscoWorks Netconfig output location

Is NetShow supported on LMS 2.5?  That's what we are running. Yeah don't laugh guys.  We don't have plan to upgrade since we are stepping up to using Solarwinds NCM.

Cisco Employee

Re: CiscoWorks Netconfig output location

No, not out of the box.  You'll need LMS 2.5.1 to get Netshow.  Neither LMS 2.5 or 2.5.1 is still supported anymore.  If you're serious about persuing LMS for show command support, download and install the 2.6 update.

433
Views
5
Helpful
7
Replies
CreatePlease to create content