It really depends on what indications you had that the card was bad. If there was a syslog message regarding the failure, then RME might have a message in its syslog standard report. In the future, you can set up Automated Actions to trap on these messages, and send out email or some other notification.
However, DFM is the fault management application in the bundle. Assuming there were managed objects on this card, and the cards failure was reported via SNMP, you should have seen some kind of Operationally Down alert associated with it.
Was the router reloaded prior to arriving at this condition? If so, DFM should have registered the reload, but since the card didn't come back online, and it looked as though it didn't exist in the chassis, DFM would not have been able to tell the difference between a simple removal and the failure.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.