Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CiscoWorks Port Security Report

We have CiscoWorks (LMS 2.6) installed on our network and we are trying to generate several custom reports. A report that we would like to have is a report to show us all switch ports that do not have port security enabled. I am able to get this information through an XML dump of switch configs using CWCLI and then doing some manipulation. However, this is a cumbersome approach and I was looking to see if anyone knew of a direct way within CiscoWorks to obtain and schedule such a report. I'm still fairly new to CiscoWorks so any assistance would be greatly appreciated.

1 REPLY
Red

Re: CiscoWorks Port Security Report

You might want to investigate the use of Baseline Templates:

RME -> Config Mgmt -> Archive Mgmt -> Baseline Templates

356
Views
5
Helpful
1
Replies