Ciscoworks QPM3.2.3 marking policy will not translate via route-map
I am running QPM 3.2.3 and want to have router originated packets to be marked at "internet" precendence. For this we used the ACL + Routemap command before using QPM. Now that I want to use QPM I need to reverse engineer the QPM config and the CLI Command reference manual says that for PBR - "Router Marking Policies will be translated via an ACL / Routemap /match IP ACL / interface/ IP policy route-map" but what I see when I do the "View CLI" in QPM it always creates an ACL and Classmap bound to a policy map for it. ( which will not capture and mark those router originated packets ) How should I do the marking in QPM to get a route-map CLI command syntax???
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...