I tried RME 4.0.5 with your template, and it works just fine if I don't check the Parameterized box.
What I did was create a new User-Defined Task in Netconfig. The Task was a Config Task for Switches and Hubs (I tested with a 3560). I did NOT check the Parameterized box, and I entered, the following in the CLI Commands box:
enable secret $x6E8s#
I then went to NetConfig Jobs, and created a new job to deploy this template to my test 3560. It deployed just fine. No errors.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...