I have been doing the synch archive of cisco MDS 9222i switch but it stopped working for some reason.
"Failed to get the start tag-Building Configuration ... in the configuration. Action: Check if protocol is supported by device and required device package is installed. Check device credentials. Increase timeout value, if required."
I have checked credentials and it is all good. Any idea ?
This is most likely caused by a timing issue when the prompt is being read for the first time. Unfortunately, there is no easy way to fix this in LMS 3.1. However, the problem is fixable in LMS 3.2. If you go to http://www.cisco.com/go/nmsevals/ and download the 3.2 eval, you can upgrade your LMS 3.1 installation to LMS 3.2. When you do, edit NMSROOT/objects/cmf/data/cmdsvc.properties, uncomment the line that contains TuneSleepMillis, then set the value of this property to 500 instead of 50. That is:
I believe your config archive job will succeed then.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...