Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Ciscoworks_rme_attributes_LMS4.2

Hi Team,

Im using LMS 4.2, and i would like to increase snmp timeout of few RME devices. I did go thru as per the below URL but did not find RME > devices > device management option at all.

Is any other way to achive this ??

To set or edit the RME device attributes for a single RME device

Resource Manager Essentials > Devices > Device Management > RME Devices.

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_resource_manager_essentials/4.2/user/guide/device.html#wp1066578

                  

The problem is that, in HUM im getting no instance avail while creating interface utilization poller. so i was thinking in increasing in hum as well as in Rme.

Regards

Rajesh

3 REPLIES
Cisco Employee

Ciscoworks_rme_attributes_LMS4.2

Hi Rajesh,

this can be achive from here:

Admin > Network > Timeout and Retry Settings > Inventory/Config Timeout and Retry Settings

Increasing the timeout may not help with the HUM issue....

are you getting the same issue for all the device in HUM ?

Thanks-

Afroz

[Do rate the useful post]

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
New Member

Re:Ciscoworks_rme_attributes_LMS4.2

Hi Afroj

When i create a new poller,l and select all 30 devices and select interface utilization, i get to see only 2 switches after clicking next.

So i think other devices are getting timedout.

Im planning to increase hum snmptimeout to 24 sec & retry to 5sec.

Due to this im not getting any interface utilization quick report for only those 20+ devices.

Any suggestions always welcome.


Regards
Rajesh


Sent from Cisco Technical Support Android App

Cisco Employee

Ciscoworks_rme_attributes_LMS4.2

Hi Rajesh,

I would suggest you to Reintialize the UPM database as below:

stop the daemon manager (net stop crmdmgtd)

NMSROOT\bin\perl.exe NMSROOT\bin\dbRestoreOrig.pl dsn=upm dmprefix=UPM

start the daemon manager (net start crmdmgtd)

and check the issue after that..

Thanks-

Afroz

[Do rate the useful post]

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
162
Views
0
Helpful
3
Replies
CreatePlease login to create content