Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

CLUSTERING ONLY TWO 4510R SWITCHES

Dear All ,

I have ony two 4510R switch,i want to put them in clusters now,also i have created one hsrp group in both switch already.Also i m attaching run config of both the switches.

Regards

Amit Kulshreshta

1 REPLY
Silver

Re: CLUSTERING ONLY TWO 4510R SWITCHES

If you plan to use clustering, enter the cluster run global configuration command on each device, and enter the ip address interface configuration command on the cluster commander.

121
Views
0
Helpful
1
Replies
CreatePlease to create content