Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CNA and a 4507 Switch

I have CNA 4.1 installed and I am trying to connect to a 4507 switch with IOS 12.2 (20)EW4. All of the modules should be supported, but when I try to connect to it I get an unsupported device error. Can someone please help?

4 REPLIES
Red

Re: CNA and a 4507 Switch

Make sure that you have the proper image (html files) loaded on the switch, and that ip http server is enabled.

New Member

Re: CNA and a 4507 Switch

Thanks for the quick reply! Do I have to have the HTML files loaded in flash to use CNA or only if I want to use the HTML interface through Internet Explorer? I had this same problem at my last job about a year ago and I can't remember what I did. Maybe I did load the HTML files. Please advise.

Red

Re: CNA and a 4507 Switch

I believe you are required to have the HTML files for CNA to work properly.

New Member

Re: CNA and a 4507 Switch

make sure that you have enabled http server on the switch

124
Views
10
Helpful
4
Replies
CreatePlease to create content