CNA and NX

[sadik.bash]

Hello,

I am trying to connect a NX7000 in the CNA(Cisco Netwrok Assistant) but it is failing. I checked the http settings on the NX7000 but it wasn't enabled. I tried to enable it but looking for the http feature but that feature isn't available. My question is, how do I enable the http on the NX and is the NX7000 approved device that the CNA will poll?

Thanks in advance, ~sK         

[Marvin Rhoads · Accepted solution]

Cisco Network Assistant does not support any of the Nexus products.

See the release notes for supported devices:

http://www.cisco.com/en/US/docs/net_mgmt/cisco_network_assistant/version5_0/release/notes/OL12210a.html


Sent from Cisco Technical Support iPad App

[sadik.bash]

Disappointed that it doesn't!

Thanks for the response, Marvin!

Best, ~sK

[Marvin Rhoads]

You're welcome. Most Nexus deals have a license for DCNM bundled. I often see this where customers don't end up installing the DCNM they are entitled. It's a full featured network management application for the data center products.

Sent from Cisco Technical Support iPad App