To my surprise I see several ports on my 4948 switch to be 10 mbit when I select the properties of those ports in the front panel view. "sh int stat" gives me the correct values. At the configure part of CNA, at port settings, all ports are on auto speed. Is this a bug in Cisco Network Assistant? Upgraded to 5.3 but still the same.
There are two tabs in CNA port settings GUI - can you check the runtime status tab and see if that value matches what you see in show int status ? It might be the case that depending on the physical media used or settings on remote end device the configured value is not the same as actual runtime speed possible for that port ?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.