Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CNC 5.1 wont install

Whilst installing the CNC 5.1 i get the following error messgaes

openfile failed

then the cnc reads...

checking swap and disk space then

error message:

regDBGetKeyValueEx failed

then error message:

cannot create the install depedency file

the install then shuts down

any help would be great

cheers

1 REPLY
Blue

Re: CNC 5.1 wont install

Could a simple case of what the message says--not enough disk space. What does "df -lk" (Sol 8/9) or "df -lh" (Sol 10) or "df -h" (Linux) look like? Any file system(s) that's nearly 100% full?

128
Views
0
Helpful
1
Replies