Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CNR 6.2 and linux

It says in the min req you need red hat ent 3.0. Can we use Red Hat ent 5? since 3.0 is quite old.

Also are we stuck with Redhat or we could use debian or another linux flavor

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: CNR 6.2 and linux

Hi Jake,

Sorry for the delay in responding.

If you have the CD version of 6.2.3 and you have a license, you should not have any problem downloading from CCO and 6.3 accepts any 6.x key...so you should be good to go.

Try this link (requires CCO id/registration):

http://www.cisco.com/cgi-bin/Software/Tablebuild/tablebuild.pl/nr-eval

Regards,

-J

6 REPLIES
Cisco Employee

Re: CNR 6.2 and linux

Hi Mr. Jake,

RedHat Linux and Solaris are the only unix-based OS's supported. Debian or any other, is not.

As for the versions of Linux, CNR only supports RH ES 3.0 and RH ES 4.0. Not 5.0. In any case, you need to be sure that the correct kit is installed for whatever version of CNR you are running. 5.0 is not yet supported with *any* version of CNR.

HTH,

-J

Cisco Employee

Re: CNR 6.2 and linux

just to be clear on this...RH 4.0 is only supported on CNR 6.3.

Regards,

-J

New Member

Re: CNR 6.2 and linux

I have version 6.2 atm. I am doing a lcean install and not an upgrade, should I try and get 6.3 instead?

Cisco Employee

Re: CNR 6.2 and linux

Definately you should get 6.3 if possible. There are many bug fixed between 6.2 and 6.3.

Regards,

-J

New Member

Re: CNR 6.2 and linux

I have a cd of version 6.2.3 and I also have a service contract for it and licenses for it. But I dont seem to be able to download 6.3. Do I need to order a new cd?

Cisco Employee

Re: CNR 6.2 and linux

Hi Jake,

Sorry for the delay in responding.

If you have the CD version of 6.2.3 and you have a license, you should not have any problem downloading from CCO and 6.3 accepts any 6.x key...so you should be good to go.

Try this link (requires CCO id/registration):

http://www.cisco.com/cgi-bin/Software/Tablebuild/tablebuild.pl/nr-eval

Regards,

-J

114
Views
0
Helpful
6
Replies