I am using a telnet/ssh proxy that will scan incoming CLI sessions for keystroke logging and command inspection.
When it notices a specific command ("show config", for example) it can insert a ctrl-C character to interrupt the command before the user executes it. We use this central method rather than tiered admin privileges on each device. Don't ask why we do it this we, we just do...it is both a blessing and a curse.
At any rate, an ASA 5505 v7.2 seems to ignore ctrl-c, so I can no longer interrupt "insecure commands". Anyone know of a command-line interrupt character for my new Cisco 7550?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...