Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Common services 3.1.1 Process problem

Hi,

Some of the process such as CS Discovery,EDS-TR,FH Purge task,in common services 3.1.1 are never started and also transient terminated even though when i manually go and start them.

CVDeviceSelector.log is not rotating after specifying in below command:

NMSROOT\bin\perl NMSROOT\bin\logrot.pl -c

for rotation:running logrot

D:\progra~1\cscopx\bin\perl D:\progra~1\cscopx\bin\logrot.pl -s

Attached is the log file for process of LMS 3.0.1 with common services 3.1.1

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Common services 3.1.1 Process problem

No, EDS-TR should never run, and FHPurge is only run periodically. It is quite common to see it as never started.

3 REPLIES
Cisco Employee

Re: Common services 3.1.1 Process problem

These process should be down in normal operation. CSDiscovery is a transient process that only runs when a Discovery is running. When Discovery ends, the CSDiscovery process will be in transient terminated. Do NOT try and start these processes manually.

Start a new thread for the logrot question.

New Member

Re: Common services 3.1.1 Process problem

Hey Joe,

what about EDS-TR and FH Purge process they are shown as never started though i have seen them as normal operation before facing this problem.

thanks

Cisco Employee

Re: Common services 3.1.1 Process problem

No, EDS-TR should never run, and FHPurge is only run periodically. It is quite common to see it as never started.

141
Views
0
Helpful
3
Replies