Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Communication failure between the SM and the SCE

i have upgard SM from 3.1.0 to 3.1.5 and after that the SCE can't sync to SM any one has work around on this issue.

SM Version: 3.1.5 Build 25 use pqi SCABB 3.1.5 build 25

SCE Version 3.1.5 Build 263

QS-2020#sh system operation-status

System Operation status is Warning

Description:

1. Lost connection with Subscriber Manager

[pcube@qs2020-sm bin]$ ./p3sm --resync-all

Error - Failed to synchronize all boxes

SCE QS-2020 had errors during subscribers synchronization: failed to synchronize 2 subscribers

[pcube@qs2020-sm bin]$ ./p3sm --sm-status

SM is running.

SM operational state is Active

Command terminated successfully

1 REPLY
Silver

Re: Communication failure between the SM and the SCE

SM failed to become Active because when a failover is initiated, there is a so-called "make-active timeout"

that is watched during the failover process, to make the failover process doesn't take indefinitely. This timeout is 40 seconds.

If the Radius Server is on the SCE subscriber side, the second accounting request on a new flow (new tuple) will end up with the SCE sends corrupted RDRs.

And also removes the anonymous-group from the SCE configuration.

383
Views
0
Helpful
1
Replies