Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

config archiving of 1232 AP's failing

Hello,

We recently installed about 100 of the AP1232 series Wireless Access Points, and CiscoWorks is unable to obtain the startup or running configs. Here's the error message:

"Failed to fetch config using SCP.Connection refused: connect Verify SCP is enabled or not. PRIMARY-STARTUP config Fetch Operation failed for TFTP. "

We're running RME 4.0.3 and the WAP is running IOS 12.3(2)JA2. Our config transport settings are (in order): RCP, Telnet, SSH, SCP, HTTPS, TFTP. I've added the commands to the WAPs to allow RCP (ip rcmd rcp-enable,

ip rcmd remote-host <userID> 10.251.0.6 <userID> enable) that has worked well on our switches. So I'm scratching my head trying to figure out why the WAP's aren't being archived and why RME is trying to use SCP when RCP is enabled. Any insights would be appreciated.

TIA,

Brian Read

1 REPLY
Bronze

Re: config archiving of 1232 AP's failing

think SCP is not supported for AP 1210 and 1230's in RME 4.0.3, check the supported device table :

http://www.cisco.com/en/US/products/sw/cscowork/ps2073/products_device_support_table09186a008055baa8.html#WirelessLAN

also check the following to configure rcp on Aironet devices :

http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_configuration_guide_chapter09186a0080184aa2.html#1035312

210
Views
0
Helpful
1
Replies
CreatePlease login to create content