Is there a way to either disble the port cost or portvlan costs from changing when NICs autonegotiate.
When the NICs autonegotiate a new speed the port cost and portvlan cost changes accordingly (which is expected) but I'd like to set this so it either doesn't get written into the config or is filtered out of the config change report in LMS 2.5.
Or is there a way to filter the port cost and/or portvlan cost from being seen by the config change reports in LMS 2.5?
I don't think you can filter a particular config in the LMS 2.5, the entire config from the device will be fetched and any changes to the config will be updated in the config change report. check out the following link for information on Archiving Configurations and Managing Them Using Archive Management :
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...