Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Config Editor Question

I ran into a slight issue in Device Center.....I went into Edit Config under Management Task to enter a Tacas Statement....but whenever I try to save it comes up with Branch Name. I have used this feature several times in the past and was wondering why is this a required field.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Config Editor Question

You need to specify a branch name when saving the config so you have a tag that identifies this local copy of the config in case future editing is required.

2 REPLIES
Cisco Employee

Re: Config Editor Question

You need to specify a branch name when saving the config so you have a tag that identifies this local copy of the config in case future editing is required.

Community Member

Re: Config Editor Question

Got it.....Thanks for the quick reply. I was confused as to what to type in that field, so I used netconfig to deploy the job I wanted instead.

109
Views
0
Helpful
2
Replies
CreatePlease to create content