Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Cisco Support Community site will be in read only mode on Dec14, 2017 from 12:01am PST to 11:30am for standard maintenance. Sorry for the inconvenience.

New Member

Config fetch Failed

Added two nex nodes on LMS 2.6.

Passed Credentials but for Telnet got: Protocol not configured. Through command line it works.

IP's are 192.168.21.62 and 192.168.152.60

Best Regards.

4 REPLIES
Bronze

Re: Config fetch Failed

Is it right, that the IP ..153.253 is your LMS server?

I assume that you deleted the user/pw configured on the device, right?

Is it possible to do a telnet session out of the device center?

New Member

Re: Config fetch Failed

Hi,

thanks.

YOu are right, we deleted user/psswd to send the file here, for security reasons.

The ip you mention, is our NNM server, CW LMS is 153.254.

192.168.152.60 is a WS-C3560E-48TD,

192.168.21.62 is a WS-C3750G-48TS, both supported on RME 4.1.1, it's a LMS 3.01, I was wrong when I wrote 2.6, sorry...

New Member

Re: Config fetch Failed

sorry, i forgot to update than telnet works from command line.

Bronze

Re: Config fetch Failed

Okay, if your LMS is the IP 254 you have to configure that IP on your ACL 1 because you have the "access-class 1 in" on line vty 0 4.

151
Views
4
Helpful
4
Replies
CreatePlease to create content