Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configuration Archieving using RCP.

I have some devices that can't archive using SSH but can only archive configs using Telnet. Is LMS 2.5 specific to SSH version 2 only?

I need to use RCP but its giving me error "Protocol ==> Unknown / Not Applicable

CM0151 PRIMARY RUNNING Config fetch failed for 172.27.233.2 Cause: Failed to fetch config using RCP.Connection timed out: connect Verify RCP is enabled or not. Action: Check if protocol is supported by device and required device package is installed. Check device credentials. Increase timeout value, if required".

I have set the RCP user to ciscoworks on the ciscoworks server and configured my devices as follows "ip rcmd rcp-enable

ip rcmd remote-host ciscoworks 172.16.15.15 ciscoworks enable

ip rcmd remote-username ciscoworks"

In the transport settings i have put RCP top on priority.

What could be the problem.

2 REPLIES
Silver

Re: Configuration Archieving using RCP.

LMS 2.5 avoid like the plague. Upgrade to 2.5.1 or even better 2.6.

Cisco Employee

Re: Configuration Archieving using RCP.

A connection timed out almost always points to a firewall between the LMS server and the device. Had RCP not been running on the device, you would have received a connection refused message. Check the connectivity between server and device, and try running "debug ip tcp rcmd" to see if the packets are actually making it to the device.

403
Views
5
Helpful
2
Replies