I have installed LMS on my entire LAN. All the devices has been displayed. But I am not able to take the configuration backup of all routers and switches. Anyone can help on this. How to take the configuration back up of switches and router through LMS.
If you're using telnet, start a sniffer trace filtering on tcp/23 traffic between the device and the LMS server. Start a new sync archive job, then when it fails, check the sniffer trace to see what credentials are being used, and what errors are encountered.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...