We have some problems working with Configuration Professional and CISCO 1811. We can see any info in VPN tab in CP but we have about 20 l2l VPN tunnels built and working on the same router. Sometimes CP doesn't populate any tabs at all while the discovery goes ok without any warnings.
We've tried this on WinXP, Vista, IE6, IE7, different Java versions but we've always got the same situation - we can see no info in Site-to-Site VPN tab.
Is there any solution and what can be done? Thank you in advance.
p.s. I used service compress-config command. May be CP is unable to read big configs?
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...