Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configure 2811 via snmp

Is is possible to configure a 2811 router with

HWIC9ESW module via snmp?

I have snmp enabled and set-up on FE0/0.

Thanks in advance

GD

Everyone's tags (1)
5 REPLIES
Blue

Re: Configure 2811 via snmp

You could place a full running config for the 2811 on a TFTP server, then use SNMP to copy it to the 2811 as described in the link:

http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a008009463e.shtml

New Member

Re: Configure 2811 via snmp

Thanks yjdabear for the reply.

I read that one and the copy config article at:

http://www.cisco.com/en/US/tech/tk648/tk362/technologies_configuration_example09186a0080094aa6.shtml

What I was after was actually being able to set a port to up and down on a switch or turn on power on a POE switch using snmp set PDUs .

Is this possible?

Thanks

GD

Blue

Re: Configure 2811 via snmp

Gary,

That sounds at least partly doable. For interface up, you could snmpset ifAdminStatus.[ifIndex number of the interface] (1.3.6.1.2.1.2.2.1.7.ifIndex) to 1 (up). As for PoE on the 2800's HWIC, it comes down to if Cisco has included support for pethPsePortAdminEnable or an equivalent OID.

New Member

Re: Configure 2811 via snmp

Thanks very much, that was helpful.

I will now have to start trawling the mibs for other interesting things to set-up

GD

Cisco Employee

Re: Configure 2811 via snmp

No, the POWER-ETHERNET-MIB is not supported in the 2800 series.  The SNMP/TFTP idea is a workaround for this.

834
Views
0
Helpful
5
Replies
CreatePlease login to create content