Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configure AS2511-RJ45 Access Server

Hello Everyone

So, I just got my AS2511-RJ45 and dont have a clue how to configure it, so I have been searching.

Please note that this device does not use an octal cable, it had 16 RJ45 Async ports.

All the config help i have found is for the one with the octal cable.

Please help

Clueless

1 REPLY
Silver

Re: Configure AS2511-RJ45 Access Server

To configure multiple asynchronous interfaces at the same time (with the same parameters), you can assign each asynchronous interface to a group and then configure the group. Configurations throughout this guide configure group asynchronous interfaces, rather than configuring each interface separately.

For the configuration following URL may help you

http://www.cisco.com/en/US/docs/ios/12_0/dial/configuration/guide/dcmodem.html#wp8562

292
Views
0
Helpful
1
Replies