Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Silver

Configuring a Cisco 1200 access point/Vlans

I has 4 VLANs and I want a MAC address has access to a VLAN, but not to another.

I used ACLs, but this will block the access to the access point, How to get the mac address will have access to a VLAN, eg no other Vlan?????

I has 4 VLANs and I want a MAC address has access to a VLAN, but not to another.

I used ACLs, but this will block the access to the access point, How to get the mac address will have access to a VLAN, eg no other Vlan?????

thank you

---

Posted by WebUser Kahina Akkouche from Cisco Support Community App

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Configuring a Cisco 1200 access point/Vlans

ACL is layer 3 aware, what you need is vACL - VLAN Access Control List.

That said, i am unsure if thats supported in AP1200's, so you might need to do that in the switches instead.

HTH

6 REPLIES
Silver

Configuring a Cisco 1200 access point/Vlans

http://www.velocityreviews.com/forums/t33333-mac-authentication-on-ap1200.html

---

Posted by WebUser Kahina Akkouche from Cisco Support Community App

New Member

Configuring a Cisco 1200 access point/Vlans

ACL is layer 3 aware, what you need is vACL - VLAN Access Control List.

That said, i am unsure if thats supported in AP1200's, so you might need to do that in the switches instead.

HTH

Silver

Configuring a Cisco 1200 access point/Vlans

thank you for your response.

I think we should create a list, I have to apply a brige of Vlan

---

Posted by WebUser Kahina Akkouche from Cisco Support Community App

Silver

Configuring a Cisco 1200 access point/Vlans

but even this does not work!! solutions?

---

Posted by WebUser Kahina Akkouche from Cisco Support Community App

New Member

Configuring a Cisco 1200 access point/Vlans

did you apply the ACL in the switch or AP ?

(I am not sure its supported in the AP)

Silver

Configuring a Cisco 1200 access point/Vlans

@mbilgrav apply the ACL in the AP

---

Posted by WebUser Kahina Akkouche from Cisco Support Community App

439
Views
0
Helpful
6
Replies