Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

configuring alerts on CW for power failures

Hi,

I'm curious to find method to configure Power failure on several devices with dual power supply. Recently some devices had major power failure with no alarms triggered on Cisco Works.

Please hlep me.

Tnx,

Satya Singh

snip from 2 devices

---------

6509:

Apr 29 %C6KPWR-SP-4-INPUTCHANGE: Power supply 2 input has changed. Power capacity adjusted to 1171.38W

Apr 29 %C6KPWR-SP-4-PSREDUNDANTMISMATCH: power supplies ratedoutputs do not match.

Apr 29 %C6KPWR-SP-4-PSINPUTDROP: Power supply 2 input has drop ped

Apr 29 %C6KPWR-SP-4-PSNOREDUNDANCY: Power supplies are not infull redundancy, power usage exceeds lower capacity supply

Apr 29 %C6KENV-SP-4-PSFANFAILED: the fan in power supply 2 has failed

Apr 29 %C6KPWR-SP-4-PSFAIL: power supply 2 output failed.

Apr 29 %C6KPWR-SP-4-PSREDUNDANTONESUPPLY: in power-redundancy mode, system is operating on one power supply.

Apr 29 %C6KENV-SP-4-PSFANOK: the fan in power supply 2 is OK

Apr 29 %C6KPWR-SP-4-PSOK: power supply 2 turned on.

Apr 29 %C6KPWR-SP-4-PSREDUNDANTBOTHSUPPLY: in power-redundancy mode, system is operating on both power supplies.

----

3745

Apr %PS-3-MULTFAIL: There is more than one failure with the Power System 2; please resolve problems immediately

1 REPLY
Silver

Re: configuring alerts on CW for power failures

I think DFM should provide these sort of alarms. You should check if your devices are correctly configured in DFM.

In the automated actions of RME syslog you can configure your own alarms with stings like

*C6KPWR*

*PS*FAIL*

Regards,

Michel

638
Views
4
Helpful
1
Replies