Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Configuring HSRP in Cisco Switches using Dynamips

Dear Friends,         

  I am in process of configuring hsrp using dynamips   

   when i am putting the comand

    SW1(config)#standby 1 ip 10.1.1.10

                                           ^                                

  % Invalid input detected at '^' marker.      

   its showing error i,e the command is support by switch ios

  Please check the show version command for ios details

"SW1#sh version Cisco IOS Software, 3600 Software (C3640-IK9O3S-M), Version 12.4(7), RELEASE SOF TWARE (fc6) Technical Support: http://www.cisco.com/techsupportCopyright (c) 1986-2006 by Cisco Systems, Inc. Compiled Wed 01-Mar-06 00:58 by alnguyen  ROM: ROMMON Emulation Microcode ROM: 3600 Software (C3640-IK9O3S-M), Version 12.4(7), RELEASE SOFTWARE (fc6)  SW1 uptime is 3 hours, 13 minutes System returned to ROM by unknown reload cause - suspect boot_data[BOOT_COUNT] 0 x0, BOOT_COUNT 0, BOOTDATA 19 System image file is "tftp://255.255.255.255/unknown"    Cisco 3640 (R4700) processor (revision 0xFF) with 94208K/4096K bytes of memory. Processor board ID 00000000 R4700 CPU at 100MHz, Implementation 33, Rev 1.2 16 FastEthernet interfaces DRAM configuration is 64 bits wide with parity enabled. 125K bytes of NVRAM. 8192K bytes of processor board System flash (Read/Write)  Configuration register is 0x2102  "

Can anyone help me in solving this issue. Any kind of help is greatly appreciated

Everyone's tags (2)
2 REPLIES

Re: Configuring HSRP in Cisco Switches using Dynamips

Hi,

SW1(config)#

you have to be in (layer-3) interface configuration mode, e.g. on a SVI:

R1#conf term

R1(config)#interface vlan1

R1(config-if)#standby 1 ip 1.1.1.1

Hope that helps

Rolf

New Member

Configuring HSRP in Cisco Switches using Dynamips

+1

300
Views
5
Helpful
2
Replies