I want to use NBAR across our network to understand what applications/protocols are being used the most. I don't at this point want to configure any policy based routing. Should I just use "ip nbar protocol discover" to see the most used protocols? Should I configure this on the serial or fasterEthernet interface? Any other options are welcome!
I think NBAR is not a application which can detect all the protocols what you are using in the network.It can give info abt the standard protocols like eigrp , citrix , rtp ..used in your network and gives info abt the packet counts.
You need to enable in the Fast ethernet as all traffic need to cross this interface.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.