Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

configuring only WRED & specifying IP prcedence

Hi,

I have 2 traffic generators, 1 is TCP & other is UDP. I wanna use them with WRED but with assigning min,max thresholds.This configuration i want to do without CBWFQ, secondly the min,max threshold command has ip-precedence(0-7) in it.

I want to assign ip precedence to these traffic sources, but i donno how. I basically wanna test behaviour of different traffic sources using WRED.

pls guide

thanx

saif

2 REPLIES

Re: configuring only WRED & specifying IP prcedence

Hi,

I think UDP would not help out for the usage with WRED . TCP would work out .

Pls use this link for ref :

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a00800c5d41.html

Hope this helps

regards

vanesh k

New Member

Re: configuring only WRED & specifying IP prcedence

thnax fot the reply. I understand your point about WRED not being helpful for UDP. but my questions are still there:

1)using WRED, how do i assign traffic for diferent precedence in order to change their min,max thredsholds.

2) Is their a way to only configure WRED & change its parameters & not configuring it throughb CBWFQ.

regards.

saif

120
Views
0
Helpful
2
Replies
CreatePlease to create content