Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

configuring PKI on cisco acs version 5.4

Hi, I new in configuring ACS 5.4. Currently I need to configure wired 802.1x PKI for server authentication . Is there any steps that I can follow to configure it?
1 REPLY
Hall of Fame Super Silver

Sure - you need to configure

Sure - you need to configure it on your clients/servers (known as supplicants in 802.1x language), on your switch (the "authenticator") and on your ACS server.

Depending on the supplicant software (native Windows or AnyConnect client Network Access Module) the instructions vary but are pretty self explanatory - just provide credentials when prompted.

The switch piece is explained in the IOS configuration guide for you platform. For instance, here is a link for a typical switch (3750-X and 3560-X).

Finally, the ACS server setup is explained here. The example is for a Lightweight AP connecting to a switch but the concept and server side setup is pretty much the same.

89
Views
0
Helpful
1
Replies
CreatePlease to create content