Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

copy run start via SNMP

Hi,

We have a mixture of 2960 switches hooked up to a 6509-E switch. We have a requirement to change VLAN port assignments on a regular basis. We have adopted a web interface approach that uses SNMP. All of the 2960s support writeMem.0, but the Cisco 6509-E does not. I need the appropriate mibs for copy running start via SNMP.

I have looked at the Cisco-Config-Copy-Mib.my. I could not get it to work, and walking the mib did not show anything.

Some help would be greatly appreciated.

1 REPLY
Cisco Employee

Re: copy run start via SNMP

The CONFIG-COPY-MIB is the way to go. Do not rely on objects from OLD-CISCO-*. This tech tip should give you all of the information you need to use the CISCO-CONFIG-COPY-MIB. If you run into problems, post what you're doing, and the error you get:

http://www.cisco.com/en/US/tech/tk648/tk362/technologies_configuration_example09186a0080094aa6.shtml

714
Views
0
Helpful
1
Replies