I installed a new 3925 yesterday to try and replace and older 3825, hence i was burdened with the task of first adapting the config to work with the 3925 which had a different hardware spec, and then copying IPT files off the CF which became a nightmare when i saw the number of files.
I somehow managed to get through the config part, but failed to make significant progress in copying the files on the CF because they were just too many. I ended up doing repeat commands like copy flash:<filename> tftp:<filename>
Is there anyway to copy all the files with just one command?
I also tried using the SDM on the router but whenever I plugged my usb flash drive into it, the router does not recognize it.
If you follow the example in the other thread, that should get you started. You can either use a script, or just enter "tclsh" mode from enable mode and type out the commands manually. Let me know if you have any other questions on using the Tcl approach.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...