Prime Infrastructure supported devices are listed here.
I don't think the 7700 has staterd shipping quite yet or it is just this month with the first ones. In any case PI does not support it. PI support for wired devices is generally quite weak. This will be changing with 2.0, due out shortly but still for Data Center , DCNM is your most full featured Cisco management offering, followed by Prime LMS and finally by PI.
DCNM will allow you to do most everything management-wise with your Nexus switches - provisioning, visualization, fault management, etc. It also fully manages the storage and unified aspects - something neither PI nor LMS do.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...