Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CRC

We can monitor interface errors from Cisco Works.Can we also monitor specifically CRC errors of devices from Cisco Works

1 REPLY
Silver

Re: CRC

You have tomake templates that it gives the CRC error on Cisco Works. For that you have to do folloowing:

RME can send notifications based on syslog messages. If the device is managed in RME and

can generate a syslog message for the error, RME can be configured to send an "automated

action" email. Go to RME > Admin > Syslog Analysis > Define Automated Action.

Click on Add to see a list of supported syslog messages.

DFM polls certain MIBs for fault management and one of these is the

OLD-CISCO-INTERFACES-MIB. The lifTable from that MIB gives CRC and other interace

information.

257
Views
0
Helpful
1
Replies