Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

CRS with CiscoView

We have LMS3.1,RME4.2,ciscoview6.1.8 and Integration Utility1.8.0 with the latest devices update but in CiscoView only we can't view the Cisco CRS-1 8-Slot Single-Shelf

System,SysObjectID:.1.3.6.1.4.1.9.1.643

The below message is appeared:

Message

Cannot find applicable device package for 10.1.0.41.

This error could be due to one of the following:

- The device package for this device type is not installed.

- Device support for this device type is not available.

- You are trying to open a component inside a device.

To correct the problem, either install a device package for the device type, or open the parent device to manage the component.

4 REPLIES
Cisco Employee

Re: CRS with CiscoView

The CRS-1 is not supported by CiscoView.

Community Member

Re: CRS with CiscoView

even with LMS3.2 ?

Hall of Fame Super Silver

Re: CRS with CiscoView

That's right - not even with LMS 3.2. See the LMS 3.2 supported device table here: http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_lan_management_solution/3.2/device_support/table/lms32sdt.html

As noted in the last two columns, CiscoView does not currently support any of the CRS models. (Campus Manager and RME DO support the various CRS-1 models.)

Cisco Employee

Re: CRS with CiscoView

No, there will not be any CRS-1 support in CiscoView. Even the GSR support is being deprecated.

188
Views
0
Helpful
4
Replies
CreatePlease to create content