Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

CSS11506 performance report ?

Is there any tools for "Cisco CSS 11506 Content Services Switch CSS11506" to provide performance report?

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: CSS11506 performance report ?

The enterprise level monitoring and management tool that Cisco makes for this class of device is Application Network Manager (ANM). See http://www.cisco.com/en/US/products/ps6904/tsd_products_support_series_home.html for information.

ANM is probably much more than you need. If you are using the Health and Utilization Monitor (HUM) component of CiscoWorks, your could set it to poll your CSS for MIB variables that are relevant to performance. Alternatively you could use a tool like CACTI or Nagios (open source management products) to do the same.

You can alternatively look at near real time monitoring on a CSS using the Web UI. See http://www.cisco.com/en/US/customer/products/hw/contnetw/ps792/products_tech_note09186a00801e05f5.shtml for setting up this functionality.

Finally, the CSS also has RMON capability. See the RMON and SNMP section of the CSS Administration Guides: http://www.cisco.com/en/US/customer/products/hw/contnetw/ps792/products_installation_and_configuration_guides_list.html

Hope this helps.

4 REPLIES
Community Member

Re: CSS11506 performance report ?

Product Name: CSS11506-2AC E0 SW Version: 07.40.0.04

Product Name: CSS11503-AC E0 SW Version: 07.40.0.04

Hall of Fame Super Silver

Re: CSS11506 performance report ?

The enterprise level monitoring and management tool that Cisco makes for this class of device is Application Network Manager (ANM). See http://www.cisco.com/en/US/products/ps6904/tsd_products_support_series_home.html for information.

ANM is probably much more than you need. If you are using the Health and Utilization Monitor (HUM) component of CiscoWorks, your could set it to poll your CSS for MIB variables that are relevant to performance. Alternatively you could use a tool like CACTI or Nagios (open source management products) to do the same.

You can alternatively look at near real time monitoring on a CSS using the Web UI. See http://www.cisco.com/en/US/customer/products/hw/contnetw/ps792/products_tech_note09186a00801e05f5.shtml for setting up this functionality.

Finally, the CSS also has RMON capability. See the RMON and SNMP section of the CSS Administration Guides: http://www.cisco.com/en/US/customer/products/hw/contnetw/ps792/products_installation_and_configuration_guides_list.html

Hope this helps.

Community Member

Re: CSS11506 performance report ?

Thanks a lot.

I installed HUM1.2 over LMS3.2, and we have special request to monitor above nodes :

1-Throughput “In & out Bandwidth”

2-Layer 4 CPS “Connection/Sec”

3-Layer 7 CPS CPS “Connection/Sec”

4-Concurrent Connections “Connection/Sec”

Is it possible to monitor content switch with HUM or I should install other application and also could you please provide me MIS's related above items.

Community Member

Re: CSS11506 performance report ?

sorry, MIS's=MIB

Is it possible to monitor above variables of content switch with HUM or I should install other application and could you please provide me mib's related above variables.

217
Views
0
Helpful
4
Replies
CreatePlease to create content