I was able to successfully configure our CUOM 2.0.3 to use our master Ciscoworks for DCR. Is it true that the slave will still do polling of the devices in the DCR db? If this is the case, will I need to configure the credentials for the CUOM to be able to poll the devices, if so where do I do that since it's a slave? Is this the reason why in CUOM I am only seeing 10 managed devices, 13 Partially Monitored, and 1977 unreachable?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...