Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Custom alert Generation

Dear Netpro's,

I wish to get e-mail alerts whenever an uplink utilisation goes above 60%.

How can we do this on LMS2.6

with thanks

sathappan

1 REPLY
Cisco Employee

Re: Custom alert Generation

First, you will need to adjust your utilization threshold to 60% for the class of interface/port you're trying to manage. This is done under DFM > Configuration > Polling and Thresholds > Managing Thresholds. Choose your interface/port type under DFM > System Defined Groups (e.g. Interfaces Group > 10/100 MB Ethernet) and click Edit. Adjust the Utilization Threshold to 60, then click OK. Finally, go to Apply Changes, and apply the changes.

To send an email when such an event is generated, go to DFM > Notification Services > Notification Group, and define a new Notification Group. Only check the boxes for events (not alerts). If the ONLY event you care about is this HighUtilization event, you can customize an Event Set under Notification Services > Event Sets. Once you have an Event Set customized, you can select it in your Notification Group.

Finally, go to DFM > Notification Services > E-Mail Subscription, and create a new subscription using the previously defined Notification Group.

96
Views
5
Helpful
1
Replies