I'm missing a function in PI 2.0 (as I know from LMS 4.2).
Reporting a MAC-Address-List by device (switch).
In PI, I've only found a report "device" ==> "wired port attribute" ==> "wired port attribute detailed report"
Here I can select "Report by Device Name" some attributes and "sort by name"
But the result has no information about the device name ... In the field "Device IP Address" is only the IP-Address of the accessed end-device filled in (e.g. a PC). In the field "Name" is filled in the name of the interface (e.g. Ethernet )
My question is now: how to create a custom report with the information "Switch" ==> "Port" ==> "connected MAC-Address" ==> if possible "connected IP-Address"
From my experience PI2.0 has very limited (basically none) custom reporting. The only customising you can do is with existing/preconfigured reports in terms of setting the dates, nr of devices reported on etc etc...
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...