Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Customizing HUM graphs

Hi,

we have HUM 1.2. In all the graphs, the top Y axis value is related to the maximun measure showed by the graph, would it be possible to configure HUM for always showing a top value of 100?

Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Customizing HUM graphs

No, unfortunately the graph definitions are not configurable. I also haven't seen this question raised before. It might make a good Product Enhancement Request for your slaes team to raise.

3 REPLIES
Cisco Employee

Re: Customizing HUM graphs

No, unfortunately the graph definitions are not configurable. I also haven't seen this question raised before. It might make a good Product Enhancement Request for your slaes team to raise.

New Member

Re: Customizing HUM graphs

Hello Joe,

And in the HUM graphs, can I join RX and TX graphs?

Thanks,

Cisco Employee

Re: Customizing HUM graphs

I don't fully understand the question.  If you mean change the graphs shown in the screenshot, then no.  If you are referring to something else, then start a new thread, and include as many details as possible.

213
Views
0
Helpful
3
Replies