Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CW Catalyst Blade Switch 3020 for HP

I'm using LMS 2.5 and I was curious whether or not if this device is supported in Cisco Works.

Model: WS-CBS3020-HPQ

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: CW Catalyst Blade Switch 3020 for HP

You can update individual device packages for RME under Common Services > Software Center > Device Update. You should have version 4.0 of the CBS3000 loaded to get the latest RME support for this device. If you do not have this package installed, you can use the Device Update interface to download and install it from Cisco.com. However, you should also check the box next to Common Services so that you pull down the latest MDF update as well.

5 REPLIES
Cisco Employee

Re: CW Catalyst Blade Switch 3020 for HP

New Member

Re: CW Catalyst Blade Switch 3020 for HP

Where do I go to download to the latest service pack for LMS 2.5?

New Member

Re: CW Catalyst Blade Switch 3020 for HP

Ok. I got access to download/upgraded to LMS 2.5.1, the device is still showing up Unknown. Where do I go in Ciscoworks to actually update the device. I already check under Common Service and Device Management didn't see the device I needed out there. Any other ideas?

Cisco Employee

Re: CW Catalyst Blade Switch 3020 for HP

You can update individual device packages for RME under Common Services > Software Center > Device Update. You should have version 4.0 of the CBS3000 loaded to get the latest RME support for this device. If you do not have this package installed, you can use the Device Update interface to download and install it from Cisco.com. However, you should also check the box next to Common Services so that you pull down the latest MDF update as well.

New Member

Re: CW Catalyst Blade Switch 3020 for HP

Thanks for the advice. I am all set.

178
Views
10
Helpful
5
Replies